My Tech Fun | Klipper with BTT Pad7 on Ender-3 V2 (with MicroSwiss NG extruder) @MyTechFun | Uploaded April 2024 | Updated October 2024, 1 minute ago.
Let's put some life into an old Ender-3 V2 using Klipper with BigTreeTech Pad7. This Ender-3 is full of upgrades, like linear rails on all 3 axis, direct drive NG extruder, CR touch. Klipper has many adventages compared to stock (Marlin) firmware, like WiFi connectivity, input shaping (bigger speed and acceleration with same quality), camera connection etc.
The product: https://biqu.equipment/products/bigtreetech-pad-7
@yogitech-3D video I mentioned: youtube.com/watch?v=pBk2D4ZiHMw
Contents:
0:00 Introduction
0:30 Specifications
2:06 Unboxing
3:26 Turning ON
3:47 Installation
7:50 Preparing for 3D printing
8:57 3D printing
9:54 Conclusions
#3dprinting #klipper #bigtreetech #pad7 #bttpad7
Let's put some life into an old Ender-3 V2 using Klipper with BigTreeTech Pad7. This Ender-3 is full of upgrades, like linear rails on all 3 axis, direct drive NG extruder, CR touch. Klipper has many adventages compared to stock (Marlin) firmware, like WiFi connectivity, input shaping (bigger speed and acceleration with same quality), camera connection etc.
The product: https://biqu.equipment/products/bigtreetech-pad-7
@yogitech-3D video I mentioned: youtube.com/watch?v=pBk2D4ZiHMw
Contents:
0:00 Introduction
0:30 Specifications
2:06 Unboxing
3:26 Turning ON
3:47 Installation
7:50 Preparing for 3D printing
8:57 3D printing
9:54 Conclusions
#3dprinting #klipper #bigtreetech #pad7 #bttpad7