Nitram | Klipper... at insane ludicrous speed... | OVER 1000000 micrometers/second | @Nitram_3d | Uploaded 4 years ago | Updated 14 minutes ago
FAST
slow youtu.be/ojJR_3fTZcE
Print settings om this particular print..
perimeters
1.1 m/s
13 m/s²
outer perimeter 70%
infill.. I couldn't even in my imagination even believe that there was any speed gained there.. so i set that low-ish... 450 mm/s and 6000 mm/s² and gained some cooling time..
The longest straight part of the the print is 144mm
I get it to a little less than 24 frames in the slowmo film(120fps) for the inner perimeters.
so 0.2 seconds to print 144mm of inner perimiters
144/0.2=720mm/s in avarage speed
I got a 10mm extended volcano at 285⁰C ABS 0.1mm layer hight and 0.4 width... 44mm³/s at max(but that is for a very very short time)... so the volume inside of the hotend helps and my printer is small...
Klipper firmware 3d printer FDM FFF speed #speedprinting
FAST
slow youtu.be/ojJR_3fTZcE
Print settings om this particular print..
perimeters
1.1 m/s
13 m/s²
outer perimeter 70%
infill.. I couldn't even in my imagination even believe that there was any speed gained there.. so i set that low-ish... 450 mm/s and 6000 mm/s² and gained some cooling time..
The longest straight part of the the print is 144mm
I get it to a little less than 24 frames in the slowmo film(120fps) for the inner perimeters.
so 0.2 seconds to print 144mm of inner perimiters
144/0.2=720mm/s in avarage speed
I got a 10mm extended volcano at 285⁰C ABS 0.1mm layer hight and 0.4 width... 44mm³/s at max(but that is for a very very short time)... so the volume inside of the hotend helps and my printer is small...
Klipper firmware 3d printer FDM FFF speed #speedprinting