Uploaded November 2026 | Updated November 2026, 12 hours ago
Kenotom is a Thessaloniki-based engineering company working on automotive firmware and electronics design, including powertrain applications such as battery management systems, DC-DC converters, inverters, and pumps. At electronica 2026, the team demonstrated a modular motor-control platform designed to adapt its hardware architecture to different microcontrollers. kenotom.com
The demonstrator drives two motors, one of them under load. Its plotted speed set point closely tracks the measured speed during a ramp, illustrating the control behavior under load. The board is shown in three variants using microcontrollers from Renesas, Infineon, and NXP, with work on other chip manufacturers also mentioned.
Kenotom’s design keeps much of the hardware similar as the microcontroller changes, allowing the architecture to be reused and optimized for each chip. The form factor can also be adapted for applications where the electronics need to fit around or inside a motor, a mechanical constraint the team describes as challenging.
The company provides firmware and electronics design services for automotive powertrain systems, including cooling, oil, and fuel pumps. The interview also touches on its early experimentation with AI tools; the team says it is still assessing their effect on productivity. Kenotom is based in Thessaloniki, Greece, and reports a team of about 160 people, most of them engineers.
Kenotom is a Thessaloniki-based engineering company working on automotive firmware and electronics design, including powertrain applications such as battery management systems, DC-DC converters, inverters, and pumps. At electronica 2026, the team demonstrated a modular motor-control platform designed to adapt its hardware architecture to different microcontrollers. kenotom.com
The demonstrator drives two motors, one of them under load. Its plotted speed set point closely tracks the measured speed during a ramp, illustrating the control behavior under load. The board is shown in three variants using microcontrollers from Renesas, Infineon, and NXP, with work on other chip manufacturers also mentioned.
Kenotom’s design keeps much of the hardware similar as the microcontroller changes, allowing the architecture to be reused and optimized for each chip. The form factor can also be adapted for applications where the electronics need to fit around or inside a motor, a mechanical constraint the team describes as challenging.
The company provides firmware and electronics design services for automotive powertrain systems, including cooling, oil, and fuel pumps. The interview also touches on its early experimentation with AI tools; the team says it is still assessing their effect on productivity. Kenotom is based in Thessaloniki, Greece, and reports a team of about 160 people, most of them engineers.










