Uploaded October 2019 | Updated November 2026, 3 hours ago
The scan gauge system is using air gauging for both the bore and the spool to provide both the OD and the ID. The system can move the head up and down simultaneously and through this the software can measure both dimensions at the same time. This system is used to assess the ‘fit’ of the pin inside the bore. Traditionally there should be 3 -5 microns clearance between the pin and the bore, and the software will not only measure the two parts but also graphically show the shape and fit of the two parts.
Software is communicating between QC-Calc and the data is being exported into the network.
For additional information:
sales@thesempregroup.com
thesempregroup.com
The scan gauge system is using air gauging for both the bore and the spool to provide both the OD and the ID. The system can move the head up and down simultaneously and through this the software can measure both dimensions at the same time. This system is used to assess the ‘fit’ of the pin inside the bore. Traditionally there should be 3 -5 microns clearance between the pin and the bore, and the software will not only measure the two parts but also graphically show the shape and fit of the two parts.
Software is communicating between QC-Calc and the data is being exported into the network.
For additional information:
sales@thesempregroup.com
thesempregroup.com










