Uploaded May 2014 | Updated September 2026, 4 days ago

---

Get everything you need for this DIY at http://rdy.cr/b6d7d4.
SUBSCRIBE TO SEALEMON DIY: bit.ly/1feEPyM

Materials:
• Venner edging - oak, 2" x 8" pack
• Glue sticks (extra strength)

Tools:
• Glue gun
• Clips (2)
• Scissors
• Pencil
• Ruler

Cut 20" strip, glue ends together.
Glue ends to center.
Clip while glue dries if needed.
Cut 8" strip, wrap around middle and glue ends on back.
Clip while glue dries if needed.
Cut two 5" strips. Mark where they will be glued on back. Glue strips to each side.
Clip while glue dries if needed.
Cut ribbon ends on 5" strips.
Tape on back to stick to gift.

Tip: Use clips for gluing. The glue on veneer is heat activated and will get too hot for fingers to hold while gluing.