@MakeTechCreate
@MakeTechCreate
MakeTech | Jack O Lantern Face with a Laser Engraver! @MakeTechCreate | Uploaded 6 years ago | Updated 6 hours ago
Using the EleksMaker Diode laser engraver to engrave a Jack O Lantern with a spooky face. This was done with T2laser with power set to 255, speed at 250 in grey-scale mode.
Jack O Lantern Face with a Laser Engraver!Uncommon CNC Bits you Should Have! - Round Over Bits, Dish Carving Bits, Mortising BitsSwallow On ceder! #pyrographyMaze Board Game #shortsCNC Bits For Beginners / Upcut Vs. DownCut Vs. Compression Vs. Ball Nose End Mills!Etching MetalLaser Cut Wood Knife SheathsDouble-Sided Tape for CNC Work Holding!Laserable Leatherette!Shapeoko 5 Pro comes to life! #woodworkingShop Fox Downdraft Sanding Table & Rockler Dust Right FlexiPort Hose Kit Dust Control SystemCO2 Laser Alignment and How to Clean Laser Lens and Mirrors / Beginner Series Ep. 5

Jack O Lantern Face with a Laser Engraver! @MakeTechCreate

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER