Uploaded January 2025 | Updated November 2026, 23 hours ago
Related links:
• Project overview | youtu.be/Tf8rzK1F0OI
• Original Instruō - tràigh [Signature Edition] overview | youtu.be/AfdHsUG6XjQ
• DivKid Winston tràigh feature | youtu.be/BCwvgQQUbi4?si
*tràigh design | Synth design series*
• Episode 1 - youtu.be/4iwu9G6zji4
• Episode 2 - youtu.be/UzohwRfge3A
• Episode 3 - youtu.be/tI0cQyLMTsg
• Episode 4 - youtu.be/xh6RkCffNgY
• Episode 5 - youtu.be/-XHrDBgti_k
*Signal Sounds Glasgow*
signalsounds.com
~~~
Hello!
Welcome to episode 4 of this module design series.
This episode is the following day from episodes 1/2/3.
Schematic is done. In this video I work through placement of the SMT components problem solving through orientation of opamps and optimal placement for most efficient signal routing.
I then work through the routing of the full board.
There are big chunks where I'm just working, so I shorted them to timelapse.
I return to real time whenever I talk about what I'm doing.
I think this session was actually ~6 hours, so I condensed it down to something a bit more manageable in length!
My apologies for the change in audio in the second half.
I took a coffee break and forgot to clip the lav mic back onto my tshirt.
So the audio is less close mic quality, but I spent a good bit of time in RX cleaning things up.
Thanks for watching!
00:00:00 Instruōduction
00:01:02 Episode 4
Related links:
• Project overview | youtu.be/Tf8rzK1F0OI
• Original Instruō - tràigh [Signature Edition] overview | youtu.be/AfdHsUG6XjQ
• DivKid Winston tràigh feature | youtu.be/BCwvgQQUbi4?si
*tràigh design | Synth design series*
• Episode 1 - youtu.be/4iwu9G6zji4
• Episode 2 - youtu.be/UzohwRfge3A
• Episode 3 - youtu.be/tI0cQyLMTsg
• Episode 4 - youtu.be/xh6RkCffNgY
• Episode 5 - youtu.be/-XHrDBgti_k
*Signal Sounds Glasgow*
signalsounds.com
~~~
Hello!
Welcome to episode 4 of this module design series.
This episode is the following day from episodes 1/2/3.
Schematic is done. In this video I work through placement of the SMT components problem solving through orientation of opamps and optimal placement for most efficient signal routing.
I then work through the routing of the full board.
There are big chunks where I'm just working, so I shorted them to timelapse.
I return to real time whenever I talk about what I'm doing.
I think this session was actually ~6 hours, so I condensed it down to something a bit more manageable in length!
My apologies for the change in audio in the second half.
I took a coffee break and forgot to clip the lav mic back onto my tshirt.
So the audio is less close mic quality, but I spent a good bit of time in RX cleaning things up.
Thanks for watching!
00:00:00 Instruōduction
00:01:02 Episode 4








