Uploaded June 2021 | Updated September 2026, 2 hours ago
I make an Industrial Style Shelf Bracket using rebar and large nail heads as rivets, to give it the real look of industrial furniture, which is the rustic style I like. A nice MIG Welding Project using rebar.
I hope you enjoy my video of the steel rebar shelf bracket project. It was a lot of fun to make. I did make other brackets exactly the same; the next ones are always much quicker to make. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like.
The main tools used are a MIG welder, angle grinder, drill, and bench vise.
The wide flat bar is 3mm thick, 42mm wide, and each side is 232mm long. The small flat bar is 6mm thick, 32mm wide, and 310mm long; the bends in this are 60mm in from each end. The rebar is 7mm.
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
I make an Industrial Style Shelf Bracket using rebar and large nail heads as rivets, to give it the real look of industrial furniture, which is the rustic style I like. A nice MIG Welding Project using rebar.
I hope you enjoy my video of the steel rebar shelf bracket project. It was a lot of fun to make. I did make other brackets exactly the same; the next ones are always much quicker to make. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like.
The main tools used are a MIG welder, angle grinder, drill, and bench vise.
The wide flat bar is 3mm thick, 42mm wide, and each side is 232mm long. The small flat bar is 6mm thick, 32mm wide, and 310mm long; the bends in this are 60mm in from each end. The rebar is 7mm.
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
