Uploaded March 2026 | Updated September 2026, 1 week ago

---

laptopscreen.com
laptopscreen.com/English/brand/HP

This is a guide on replacing a screen on HP ProBook 445 G10.

To begin turn off the laptop and disconnect the power cord.

Start removing the bezel. Insert a plastic pick between the bezel
and the LCD from the inner side. Move it along the perimeter.
Insert a plastic pick between the bezel and the back cover.
Move along the edges unsnapping the bezel. The hinge cover is
attached to the bezel. Use plastic pick release the hinge cover.
Turn the laptop sideways and insert a plastic pick between the bezel and the
back cover. Move the pick vertically releasing the bezel.
Place the bezel aside.

The screen is held in place with five adhesive strips:
four at the corners and one small at the top near the webcam.
Using tweezers pull out adhesive strips from the top corners.
Using the same technique pull out adhesive strips from the bottom corners.
Pull out small adhesive strips at the top of the screen.

Place the screen on the keyboard. Peel off the silver and clear tapes
securing the video connector. Open the connector’s bracket. Disconnect
the video cable. Discard the old screen.

Place the new screen on the keyboard. Reconnect the video cable.
Close the connector’s bracket and secure it with tapes.

CAUTION! It is very important not to force any connectors. Also
make sure not to twist or slant the connector when plugging it in.

Now we can test the screen. Lift the screen up and lean it against the back cover.
Reconnect the power cable and turn the laptop on. The screen is
working and we can finish installation process.

Place the screen back on the keyboard.
We are going to use a set of adhesive strips which you can buy on our site:
Laptopscreen.com.

Use alcohol and a piece of cloth to clean the sides of the screen.
Apply adhesive strips. Peel off protective film. Lift the screen up and apply some
pressure. Remove protective film.

Replace the bezel. Open the laptop to 180 degrees. Fit the hinge cover in place.
Then go around the perimeter snapping bezel in place. Use both hands
to snap bezel near the hinge cover. Turn the laptop sideways and make sure
that bezel is snapped at the bottom.

Turn the laptop on. And we are done!