HP 54540C Oscilloscope, Fault: SOFTWARE ERROR. Part 1 @waynephillips1848
HP 54540C Oscilloscope, Fault: SOFTWARE ERROR. Part 1  @waynephillips1848
Uploaded March 2021 | Updated November 2026, 3 days ago
while testing an input signal i pressed the "Auto-Scale button" after a few clicks the scope locked up, and now will only show the below Error code. "SOFTWARE ERROR - PLEASE RECORD THESE NUMBERS 9A8E 00102008 00FF"
checked the power supply module voltages both in circuit and with a 2 ohm load. All voltages found to be correct.
Replaced the bios 3.0v battery and new install of the ROM and SYSTEM files from a 1.44 MByte floppy disk. Tried the two versions available, Unreleased software rev T2.26 and Released software rev 2.00.
Both installed OK, but i still get the above Software error code.
The mother board is 98% surface mount components, i have checked the caps for leakage and can see no signs of any burnt tracks, removed and cleaned the ADC hybrid modules. Part 2 is to test the ROMs!!!
internal PSU part No. 0950-2369
HP 54540C Oscilloscope, Fault: SOFTWARE ERROR. Part 1Elecraft KX3 fitting KXAT3 internal ATUiOptron MiniTower Altitude Locking Knob DIY UpgradeFluke 196C ScopeMeter, Basic Probe Cal & Functions.CREWORKS 8x14 Mini Lathe, Quick Change Tool Post Holder, QCTPSurecom SW-102HF, unbox and test, Marconi 2966ATUXING Pcp Air Compressor, TXET063, FAIL, 20 Bar out of calibrationBulldog ST Alpha Airsoft Gun, review & chronograph testIC-7700, FTM400, IC-271H using RODE NT1-A & Behringer MIC2200, FBQ1502HD MX822Amstrad 8060 Fix Power Button, Volume pot and Replace Cassette Belts, Part 3MotoRadds Motorcycle Chin Mount on Schuberth C4,  tested on BMW R1200GS with GoPro
Waynes Share the Knowledge |

HP 54540C Oscilloscope, Fault: SOFTWARE ERROR. Part 1

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER