How to use RME Audio TotalMix FX - 09 Using Loopback @RMEAudio
How to use RME Audio TotalMix FX - 09 Using Loopback  @RMEAudio
Uploaded May 2015 | Updated November 2026, 2 days ago
Loopback is a special and very useful feature in TotalMix FX. With Loopback, you can take output of one software program, and send this back as an input signal for a different software program. Or you can create a mix of input signals, playback signals, or both, and send this back as a stereo input for recording. It works just like plugging a cable from an output channel to an input channel, except it all happens inside TotalMix and therefore works completely transparent.

Let’s look at this in action. Click the AES Out channel in the bottom row, and route some audio to this output.

In order to activate loopback on the output channel, click the tool icon to access the settings. Next, click the Loopback button to activate. The signal present at the output is now sent to the corresponding input channel in software. So, since we used the AES output, we would receive the input signal on AES In.

Notice that TotalMix will not show this signal on the input row. These meters always show signal present at the actual input.
How to use RME Audio TotalMix FX - 09 Using LoopbackTotalMix FX for Beginners - Channel GroupsTotalMix FX for Beginners - Trim GainsWim Daans, the Fireface UFX and ADI-648RME Audio TotalMix FX - 10 Trim GainRME Fireface UFX -  Low Latency Pro Audio InterfaceRME Audio ARC USB - A/B Speaker Setup in TotalMix FXMusic Studio of the Future: AVB Network Audio Walkthrough at elysiaHow to use RME Audio TotalMix FX - 08 Using EffectsUSB 3.0 Audio Interface - RME Audio MADIface XTTotalMix FX for Beginners - Adding FXRME Essentials: VST Plugins in TotalMix with LiveProfessor
RME Audio |

How to use RME Audio TotalMix FX - 09 Using Loopback

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER