How to Strip - the Process for Adding Strips to my Kayak @JackmanWorks
How to Strip - the Process for Adding Strips to my Kayak  @JackmanWorks
Uploaded October 2024 | Updated November 2026, 11 hours ago
Here’s the entire process for installing a strip in the deck of the kayak. I start with a bevel gauge to measure the angle, since every strip is different. Then I mark and cut that angle and test the fit. The angle is refined with a block plane until it fits perfectly against the previous strip so that the cut end and the intersecting strip are perfectly parallel. On the end I cut a cove with the same router bit I used to mill the strips, and then install the piece in place to test the fit. Sometimes that’s all I need to do and sometimes it takes a little more refining to make it perfect. Then I glue the strip in place with @titebondproducts 3 and use all the clamps I own to hold it in place (since I’m not using staples). So really, it’s a super satisfying and fairly easy process, if only I didn’t have to do it over 100 times and wait for the glue to dry between each strip 😅. Hearing protection is the Free Aware from @isotunes and also shoutout to the @hillview_tool bevel gauge and block plane.
How to Strip - the Process for Adding Strips to my KayakLevel HolderNightmare Bent LaminationStructure for the Boot - Fiberglassing (and stain)Secret Adirondack Chair Feature“Pallet Duck” DIY wood kayakMy Dad’s Woodworking 😬Adirondack Chair… but better!Building a Wooden Boot?Wood Veneer Inlay (with a laser)Mondays…Kayak Apron - Customized with WALNUT Pallet Wood
Jackman Works |

How to Strip - the Process for Adding Strips to my Kayak

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER