Uploaded March 2013 | Updated November 2026, 3 hours ago
Yeah, right, like I'm going to solder 56 LEDs individually.
Some things which aren't in the video:
You ABSOLUTELY MUST use flux, or else the solder isn't going to stick to anything.
Make sure the solder is AT LEAST 500°F (278°C) or you'll get lots of solder bridges like I did.
God forbid you're using lead free solder. Then it would have to be probably 700°F (389°C).
Use 60/40 for the best results. Get the good stuff such as Kester if you can afford it.
Temperature controlled solder pots are nice.
For larger boards, the pot has to be close to overflowing.
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
Yeah, right, like I'm going to solder 56 LEDs individually.
Some things which aren't in the video:
You ABSOLUTELY MUST use flux, or else the solder isn't going to stick to anything.
Make sure the solder is AT LEAST 500°F (278°C) or you'll get lots of solder bridges like I did.
God forbid you're using lead free solder. Then it would have to be probably 700°F (389°C).
Use 60/40 for the best results. Get the good stuff such as Kester if you can afford it.
Temperature controlled solder pots are nice.
For larger boards, the pot has to be close to overflowing.
DON'T FORGET TO CHECK OUT MY PATREON! patreon.com/The_Lightning_Stalker
Twitter: @lgtngstk
![[YTP] Boshua Jardwell is CS188
motors [YTP] Boshua Jardwell is CS188](https://i.ytimg.com/vi/3CMY41teS9k/mqdefault.jpg)









