Uploaded June 2025 | Updated September 2026, 2 weeks ago

---

youtube.com/watch?v=q9zIi9T5Vc4

laptopscreen.com
laptopscreen.com/English/brand/Razer

This is a guide on replacing a screen on Razer Blade 17 RZ09-0423Q
For the replacement process we will need just a plastic pick.
To begin turn off the laptop and disconnect the power cord.
Insert a plastic pick between the bezel and the LCD. The bezel is held in place
with glue and a rubber insulation. Move the plastic pick around the perimeter.
separating the bezel. Put the bezel aside. Removed the remaining glue and rubber insulation.
We going to replace the glue later.
The screen in held in place with adhesive strips on left and right sides with loose
tabs at the bottom. Using loose tab pull out the adhesive strip on the right side.
Pull out the adhesive strip on the left side.
Place the screen on the keyboard. Using plastic pick and fingers peel off the clear tape
securing the video cable. Using plastic pick open the connector's bracket.
Disconnect the video cable and discard the old screen.
Place the new screen on the keyboard. Reconnect the video cable. Close the connector's bracket.
Secure it with clear tape. Now we can test the screen. Lift the screen up and lean it on the back cover.
Reconnect the power cable and turn the laptop on. The screen is working and we can finish
the installation process.
Place the screen back on the keyboard. Using alcohol and micro fiber cloth clean the sides of the
screen and the inner surfaces of the back cover.
Your new display may not come with adhesive. We offer standard double-sided tape for such repairs
on our site: laptopscreen.com
Apply the new adhesive strips and lift the screen up. Apply some pressure on the sides to catch the glue.
In order to replace the bezel we need to use a 1/8 inch double sided super adhesive tape. Cut 2 pieces
of adhesive tape and apply them on the left and right sides of the bezel. Replace the bezel.
Press firmly along the perimeter to catch the glue.
Turn the laptop on. And we are done!