@craigdabler-thediycastings7511

@craigdabler-thediycastings7511

Craig Dabler - The DIY Castings Guy | How to Mark a Graver Handle @craigdabler-thediycastings7511 | Uploaded April 2019 | Updated October 2024, 6 hours ago.
Using a ball bur to cut into the wood handle of a graver.

How to Mark a Graver Handle

Mold Making - Powder Separation - Experiment

Toaster Oven Vulcanized Silicone Rubber Mold of Tree Twigs - Video Two

Step One: Soldering the Brass Rod to the Item

Learning to Operate a Jewelry Torch

Determining Width When Carving a Wax Band

Red Clay Casting - How to Setup the Flask if the Pattern is Fragile.

Red Clay Casting - Vacuum Assist - Video 1

Red Clay Casting - Setup of the 4 Inch Flask to Sand Cast Multiples - Video 1

Inexpensive Vacuum Set Up

Casting - Kitchen Stove Burnout - Video 6

Instructions On Sticky Crucibles

How to Mark a Graver Handle @craigdabler-thediycastings7511