TimberWood Customs | How To Make Those Cool Time Lapses but with CURA and a GoPro!!! @TimberWood.Customs | Uploaded September 2018 | Updated October 2024, 9 hours ago.
Thanks For Watching! Don't forget to share this video!
SUBSCRIBE and hit that LIKE button!
http://youtube.com/channel/UCAmYIDI_f...
Don't Forget to go check out these awesome printers! Use this link to help me and the channel out! http://tevo-3d-onlinestore.myshopify.com?rfsn=1744113.87e0c3
Instagram: instagram.com/_le.3d_printing
Twitter: twitter.com/Snowoarder_301
Thingiverse: http://thingiverse.com/Streccius11/de...
Devins Video: youtube.com/watch?v=Is10iN43UjI
Gcode needed:
;START of TakePhoto routine
G91 ;Use relative positioning mode
G1 E-10 F1800 ;Retract 10mm of filament
G1 Z2 F2000 ;Move Z up 2mm
G90 ;Use absolute positioning mode
G1 F13000 X288 Y210 ;Quick move to rear right
G1 F1000 X289 ;Poke
G1 F9000 X288 ;Move 1mm to the left
G4 P500 ;Pause for 0.5 seconds
G91 ;Use relative positioning mode
G1 E9 F1800 ;Restore filament
G1 Z-2 F2000 ;Return Z to current layer
G90 ; Go back to absolute position mode for all axes
;END of TakePhoto routine
(This has retraction enabled and z hop so it doesn’t bump into the other layer when moving back into position)(Also remember to put in your X coordinates that fit your printer distance) also a big thank you to Toufong Vang for also helping out with the retraction settings!
Thanks For Watching! Don't forget to share this video!
SUBSCRIBE and hit that LIKE button!
http://youtube.com/channel/UCAmYIDI_f...
Don't Forget to go check out these awesome printers! Use this link to help me and the channel out! http://tevo-3d-onlinestore.myshopify.com?rfsn=1744113.87e0c3
Instagram: instagram.com/_le.3d_printing
Twitter: twitter.com/Snowoarder_301
Thingiverse: http://thingiverse.com/Streccius11/de...
Devins Video: youtube.com/watch?v=Is10iN43UjI
Gcode needed:
;START of TakePhoto routine
G91 ;Use relative positioning mode
G1 E-10 F1800 ;Retract 10mm of filament
G1 Z2 F2000 ;Move Z up 2mm
G90 ;Use absolute positioning mode
G1 F13000 X288 Y210 ;Quick move to rear right
G1 F1000 X289 ;Poke
G1 F9000 X288 ;Move 1mm to the left
G4 P500 ;Pause for 0.5 seconds
G91 ;Use relative positioning mode
G1 E9 F1800 ;Restore filament
G1 Z-2 F2000 ;Return Z to current layer
G90 ; Go back to absolute position mode for all axes
;END of TakePhoto routine
(This has retraction enabled and z hop so it doesn’t bump into the other layer when moving back into position)(Also remember to put in your X coordinates that fit your printer distance) also a big thank you to Toufong Vang for also helping out with the retraction settings!
