Uploaded October 2023 | Updated September 2026, 2 weeks ago

---

In this video, I will show you how to make automated fan than can be controlled with temperature change. it can be used in machinery where exhaust fan turn on when temperature reach to specific limit and turn off automatically when it is cool down using Arduino.

Stuff used in this Project :

Arduino uno: flyrobo.in/arduino_uno_r3_with_cable_for_arduino_uno?tracking=5b853f18ae9a2

DHT11: flyrobo.in/dht11-temperature-and-humidity-sensor-module-with-led?tracking=5b853f18ae9a2

Display: flyrobo.in/iic_i2c_backlight_lcd_display_module_for_arduino?tracking=5b853f18ae9a2

Potentiometer: flyrobo.in/wh148-10k-ohm-3pin-15mm-shaft-single-potentiometer?tracking=5b853f18ae9a2

Fan: flyrobo.in/5v-3007-cooling-fan?tracking=5b853f18ae9a2


Jumper Wires: flyrobo.in/combo-of-3-type-jumper-cables-f-f-f-m-m-m?tracking=5b853f18ae9a2

Bread board: flyrobo.in/mini_solderless_breadboard__170_tie_points_for_arduino_diy_project?tracking=5b853f18ae9a2

Codes and diagram: drive.google.com/drive/folders/1uFXr_AadE47TU7PNU9ztYm96468ft2CI?usp=sharing

Music: Paradise
Musician: @iksonmusic