Uploaded October 2019 | Updated September 2026, 23 hours ago
How to layout the geometry for a dog clutch and cut the teeth
Depending on your hole sizing and number of teeth you can greatly simplify the cutting geometry with 1 cut per tooth. The alternative method (not shown here, everyone else tends to do this) requires 2 cuts per tooth with the second cut requiring a lateral offset.
This part is for the mill powerfeed project coming soon
I have a patreon account if you wish to help support the channel. Through this you can get early access and more
patreon.com/tommygmachining
If you are interested enough to read this far, you had better Subscribe!
How to layout the geometry for a dog clutch and cut the teeth
Depending on your hole sizing and number of teeth you can greatly simplify the cutting geometry with 1 cut per tooth. The alternative method (not shown here, everyone else tends to do this) requires 2 cuts per tooth with the second cut requiring a lateral offset.
This part is for the mill powerfeed project coming soon
I have a patreon account if you wish to help support the channel. Through this you can get early access and more
patreon.com/tommygmachining
If you are interested enough to read this far, you had better Subscribe!
