How to make 3 DIY SHOTGUN SHELL projects @EamonWalshDIY
How to make 3 DIY SHOTGUN SHELL projects  @EamonWalshDIY
Uploaded June 2017 | Updated November 2026, 3 hours ago
How to make 3 DIY SHOTGUN SHELL projects
#1 Picture frame
#2 Key rings
#3 Refrigerator magnets
***Obviously the shells/cartridges have been used. Never cut into or heat live ammunition.
The timber for the picture frame is 3 x 11-2 inches.It is built to suit a 20 inch x 16 inch picture including the border. It has simple 45 degree angles on the corners which are glued and nailed. I used a router to make the rebate to house the picture and backing. The holes were drilled with a 20 mm spade bit and the frame is finishes with a black gloss spray paint. The photograph is a personal photograph of mine which i too a few years ago.

For the key rings I used some off cuts of wood to create a dowel that would fit into end of the shell. I used a block plane and sand paper for this. I used a hot iron to separate the plastic and the metal of the shell. The wood is stained in a walnut stain and finished in lacquer which is not shown in the video. The wood is attached to the shell part with gorilla super glue.

For the magnets I again separated the shell from the plastic with a hot iron. The magnets were purchased on eBay and were stuck into the shell with glue. I used some floor protectors on the end of the magnets to protect whatever surface they were on from scratches.
Thanks to my brother for firing the shots for the video.

Always be safe and careful when using tools and machinery!!

Music: YouTube audio library
How to make 3 DIY SHOTGUN SHELL projectsHow to make a set of coasters
Eamon Walsh DIY |

How to make 3 DIY SHOTGUN SHELL projects

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER