How to install an amp to a factory radio with line output converter @jptheinstallguy
How to install an amp to a factory radio with line output converter  @jptheinstallguy
Uploaded January 2026 | Updated November 2026, 21 hours ago
how to install an amp to a factory radio with line output converter
In this video we go over the ways to install an amplifier to your factory radio with a line output converter. the steps are pretty easy especially if you have visible rear deck speaker. in this car we found the speaker wires in the rear, found out which was positive and negative and i showed how to install the line output converter so you can use the high level signal from your factory radio and output a low level signal for the amplifier.

*Parts used in install:*
Line output converter jpsaudio.com/product-page/pac-lp7-2
Speaker Tester jpsaudio.com/product-page/install-bay-ibr68-speaker-tester

*Grab My New Book: Introduction To Car Audio Vol1. Car Stereos*
jpsaudio.com/product-page/introduction-to-car-audio-book-vol1-car-stereo

*TAGS*
#amplifer #lineoutputconverter
How to install an amp to a factory radio with line output converterlast part of installing 2 amplifiers in a2024 jeep wranglera quick and simple amp board installation using kicker 800.1 amphigh Current Amplifier Grounding Pack Back In stockwent i switched from snap on to Milwaukee drillslets light up that amplifier installationdont cut that wire harness let me help you install your radio correctlyhow to wire subwoofers for your ampinstalling the audiocontrol 5ch amp in purple haze 💜 2026 jeep wranglerNew led amplifier risers now for audison sr amplifiersgot them back in stock smd fuse blockshow to extend your subwoofer wires
JPtheinstallguy |

How to install an amp to a factory radio with line output converter

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER