How to Ignite an Empty Zippo Lighter @vonmalegowski
How to Ignite an Empty Zippo Lighter  @vonmalegowski
Uploaded August 2014 | Updated November 2026, 9 hours ago
Gear & Studio Setup List: vonmalegowski.blogspot.com/2020/06/von-malegowskis-equipment-list-2020.html

This quick survival and EDC trick shows how to get a flame out of an "empty" Zippo lighter without adding any extra lighter fluid. Even after a Zippo stops lighting normally, the internal packing rayon/cotton still holds trace fuel vapors, and the dry fibers themselves act as ready-made tinder that can catch a spark from the flint wheel.

Zippo Lighters: amzn.to/33rWkP6

How It Works

1. Pull the metal lighter insert out of the outer Zippo case and lift the felt pad at the bottom to pinch out a small tuft of internal cotton packing.

2. Fluff and pull the fibers apart so there is plenty of surface area and airflow to catch a spark.

3. Tuck the fluffed cotton next to the wick inside the chimney, keeping it just clear of the striker wheel, so the wheel spins freely.

4. Strike the flint wheel (rolling it across a firm surface if needed for a stronger spark) to ignite the cotton, then immediately transfer the flame to tinder or a candle since the small tuft burns up in seconds. (Recently emptied lighters catch almost instantly from residual vapor, while completely dry lighters take a few extra strikes.)

Handle the open flame carefully so you do not singe your fingers when the fluffed cotton flashes up, and avoid pulling out so much packing that the lighter cannot properly hold fluid when you refill it later.

Music: YouTube Audio Library
Track: Parasail
Artist: Silent Partner
creativecommons.org/licenses/by/3.0

#Zippo #EDC #SurvivalTricks
©Von Malegowski. All Rights Reserved.
How to Ignite an Empty Zippo Lighter
Von Malegowski |

How to Ignite an Empty Zippo Lighter

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER