How to flash RubyFPV to Runcam WiFilink v2 (and initial setup) @JoshuaBardwell
How to flash RubyFPV to Runcam WiFilink v2 (and initial setup)  @JoshuaBardwell
Uploaded May 2025 | Updated November 2026, 4 days ago
Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: fpvknowitall.com/ultimate-fpv-shopping-list

SUPPORT ME ON PATREON at: bit.ly/2Ep5Sia

THIS IS MY FULL TIME JOB. Here are other ways that you can support me: fpvknowitall.com/support-me

---

00:00:00 - You need to flash the Wifilink. But how?

User manual for the Wifilink vRX is at the product page: shop.runcam.com/runcam-wifilink-rx

00:02:43 - Download the required files

Runcam's Google Drive link: drive.google.com/drive/folders/1moljMrfbCeSgvW7LQA1RAOpFrKZshpGI

Download RubyFPV image at: rubyfpv.com/downloads.php

00:03:30 - Install the driver
00:03:59 - Run and setup RKDevTool
00:05:01 - How to get MASKROM mode
00:06:29 - Flash the firmware
00:07:58 - You can run firmware off an SD card
00:09:10 - You don't need to flash your vTX!
00:10:09 - Search for vehicle
00:11:29 - RubyFPV Betaflight OSD Setup
00:13:22 - Confirm board type = Runcam V2
00:13:52 - Select a clean channel
How to flash RubyFPV to Runcam WiFilink v2 (and initial setup)Yes it is SAFE to charge inside your RadiomasterQ&A Livestream - September 21, 202670% more video range & penetration! // RUSHFPV 3.3 GHZ VIDEO RECEIVERXT60 to USB Fast-Charge! NO MORE OVERPRICED POWER BANKS!Q&A Livestream - November 23, 202504 - How to plan a REAL cross-country mission with iNavSub250g FPV Drone Build - 05a - Analog OSD Setup (oops I left this out)Copy & Clone Models Between EdgeTX Radios   EVEN DIFFERENT RADIOS!GoPro Status in BF OSD! Remote start/stop record! // SHUTTERBRIDGEFCC Updates Covered List to Exempt Certain DronesELRS(TM) was ATTACKED by trademark theft!!!
Joshua Bardwell |

How to flash RubyFPV to Runcam WiFilink v2 (and initial setup)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER