Uploaded June 2023 | Updated September 2026, 2 weeks ago

---

Edit: I think my retraction settings were off. Clogged when printing my top aimers twice. After some tests Retraction Distance 4.5 - Retraction Speed 30 - and I dropped down the Temperature to 200 for Zero filament to finally reduce over extrusion and stringing. Haven't tested a full print. Retraction / Stringing test file: thingiverse.com/thing:2080224

I use a .6 nozzle.
Top/Bottom Pattern.
Z Seam alignment.
Get your temperatures right.

I forgot to go over Power Loss Recovery. I think? I disabled it. This guy goes over it. Disabling it might remove some stutter blobs. youtu.be/ZM1MYbsC5Aw

My Rec Room Pistol and STL file: youtu.be/Xb71KWrNc4c

My 3d Printing playlist, videos I made or found helpful: youtube.com/playlist?list=PLZmxphDghll4zzdn4KCne8yqgT3irTEnC

Fang fan mount: thingiverse.com/thing:3676132

If your temperatures are not holding steady - check out this video and its description: youtu.be/5PZxkslRYkg - my temperature wasn't holding steady because my thermistor wire wasn't secured properly.