Uploaded August 2026 | Updated November 2026, 6 hours ago
Modern radar -- the kind in every new car -- pulls the distance AND the speed of every target out of thin air, dozens of times a second. Here is exactly how, built from the raw signal.
It transmits a CHIRP: a tone whose frequency ramps up over about 40
microseconds, then repeats. The echo from a target is just a delayed copy. Multiply the transmitted chirp by the received one and you get a single beat tone whose frequency is proportional to the target's RANGE:
f_beat = 2 (B/Tc) R / c
An FFT along "fast time" -- the samples within one chirp -- turns that beat frequency into a range axis. One FFT, and you have the distance to everything in front of you.
Speed takes a second FFT. Between one chirp and the next, a moving target nudges the echo's phase by a tiny amount set by the Doppler shift:
f_Doppler = 2 v / lambda
Stack 128 chirps and FFT along "slow time" -- the chirp index -- and that phase drift becomes a velocity axis.
Two FFTs of the same block of samples give the RANGE-DOPPLER MAP: one bright blob per target, its height telling you how far, its sideways position telling you how fast. In the animation the targets move, so watch the blobs slide along range while their Doppler holds steady -- except the one that accelerates, whose blob drifts sideways too.
This is what the phased arrays from the earlier videos are actually pointing: the array aims the beam, and this is what it computes with what comes back.
Made with Python + Matplotlib. The detected blob positions were checked against the known target ranges and velocities before rendering.
#radar #dsp #engineering #fmcw #signalprocessing #electronics
Modern radar -- the kind in every new car -- pulls the distance AND the speed of every target out of thin air, dozens of times a second. Here is exactly how, built from the raw signal.
It transmits a CHIRP: a tone whose frequency ramps up over about 40
microseconds, then repeats. The echo from a target is just a delayed copy. Multiply the transmitted chirp by the received one and you get a single beat tone whose frequency is proportional to the target's RANGE:
f_beat = 2 (B/Tc) R / c
An FFT along "fast time" -- the samples within one chirp -- turns that beat frequency into a range axis. One FFT, and you have the distance to everything in front of you.
Speed takes a second FFT. Between one chirp and the next, a moving target nudges the echo's phase by a tiny amount set by the Doppler shift:
f_Doppler = 2 v / lambda
Stack 128 chirps and FFT along "slow time" -- the chirp index -- and that phase drift becomes a velocity axis.
Two FFTs of the same block of samples give the RANGE-DOPPLER MAP: one bright blob per target, its height telling you how far, its sideways position telling you how fast. In the animation the targets move, so watch the blobs slide along range while their Doppler holds steady -- except the one that accelerates, whose blob drifts sideways too.
This is what the phased arrays from the earlier videos are actually pointing: the array aims the beam, and this is what it computes with what comes back.
Made with Python + Matplotlib. The detected blob positions were checked against the known target ranges and velocities before rendering.
#radar #dsp #engineering #fmcw #signalprocessing #electronics


![🇹🇷 Summit walk in Western Taurus Mountains in Elmalı, Antalya (~2580 m) [2015] #toroslar
Our summit walk on August 17, 2015 from village of Yapraklı (Güğü Beli) to the peak of Güldürgü of ~2580 m. The local names of points we have crossed along our walk are as follows:
Ahırlı, Ayamdaş, Zircalan, Ağa damı, Tozluca, Kara Muğar, Güldürgü Zirvesi, Eşek yeri, Ak muğar - dedenin yeri, Yazlık, Yazlığı muğar, Yanığın yüzü, Ahırlı
There is no known trail apart from the nomadic goat paths used during herding seasons. At various locations, one can find spring water coming out of the ground. For such springs, just watch for relatively larger trees nearby. Also, if available you can ask to the shephards nearby.
GPS coordinates of our walk can be reached from here:
https://www.wikiloc.com/hiking-trails/gugubeli-guldurgu-zirvesi-2600-m-peak-10645002
0:00 Start
0:18 Güğü Beli
0:49 Peak
8:17 Goat calling
Other hikes around:
Same mountain in 2023: https://youtu.be/n8NqcbrRIBQ
https://youtu.be/nBd_kyCeJBg
#taurusmountains #toroslar #akdaglar #ahirli #likya #lycia #hiking #turkishmountains #mountains #nomadiclife #villagelife 🇹🇷 Summit walk in Western Taurus Mountains in Elmalı, Antalya (~2580 m) [2015] #toroslar](https://i.ytimg.com/vi/qq2Igkjw3_w/mqdefault.jpg)

![🇬🇪 Georgia Road Trip - Turkish Border to Akhaltsikhe via Akhalkalaki [Ahıska] [Part 1]
Right after passing the recently opened Turkish-Georgian border (so-called Aktaş Sınır Kapısı), we head towards Akhalkalaki. From there, we turned towards North to the curly canyon roads to reach Ahıska (Akhaltsikhe). Although the road is narrow and shared for both ways and sometimes with potholes, the stunning mountain views compensate for those. Along the way we stop at the Khertvisi Castle.
0:00 Right after Turkish Border
1:12 Akhalkalaki Kalesi/Castle
5:00 Road towards Khertvisi, Khando, Chunchka
10:02 Khertvisi Castle / Kalesi
Turkey, Georgia and Azerbaijan border crossings: https://meyavuz.wordpress.com/2019/09/29/gurcistan-ve-azerbeycana-sahsi-araba-ile-giderken-gerekenler/
Photos and details of the whole trip will be available here (currently under construction):
https://wp.me/p1mKpD-eI 🇬🇪 Georgia Road Trip - Turkish Border to Akhaltsikhe via Akhalkalaki [Ahıska] [Part 1]](https://i.ytimg.com/vi/req1w1O-qDU/mqdefault.jpg)





