How I fire my ornaments #ceramics @OldForgeCreations
How I fire my ornaments #ceramics  @OldForgeCreations
Uploaded October 2026 | Updated November 2026, 1 hour ago
This is probably the aspect of making the ornaments that I get asked about most often, but there's no solution that will be perfect for every situation.

If you can get alumina rods though, they are well worth it. I use 6mm diameter and 100mm length, although obviously those dimensions are very specific to the ornament. A bigger/smaller ornament will need a different set of measurements.

And I found the factory through Alibaba. Most of them have a minimum order that's unrealistic for a personal order, but some will allow you to place a smaller order.

#pottery #ceramics #glaze #firing #ornaments

Support the creation of more videos on Patreon: patreon.com/oldforgecreations

For examples of my work that's been glazed, check out my Instagram:
instagram.com/oldforgecreations

Buy my work, or read more on my blog:
oldforgecreations.co.uk

Link to tools: oldforgecreations.co.uk/recommended-tools
How I fire my ornaments #ceramicsThis years Slipcast Ornament Design #ceramics #3dprinting(Hint: its a pottery tool) #ceramics #3dprintingI shared the STEP file for the mould base, heres how to add your own designsThis one might not make it to Makerworld 😂 #pottery #3dprintedClay shrinkage - How to account for that!  #ceramicsStamping a Nautilus pattern into liquid clay  #potteryDrippy Slip Mug - Controlling the marbled colours (a bit)  #ceramicsUsing a Flux Glaze to make others more interesting #ceramics3D Print, then Plaster, then LASERS, then Clay #ceramicsWould you be interested in a printable mould for ceramic pipes? #3dprinted #ceramicI FINALLY replaced my ornament dipping tool! #ceramics #3dprinting
Old Forge Creations |

How I fire my ornaments #ceramics

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER