How I built our floor level timber decking @GosforthHandyman
How I built our floor level timber decking  @GosforthHandyman
Uploaded July 2024 | Updated September 2026, 2 weeks ago
Our decking project is finally complete! In this video I’ll show you how we built our decking and give you some tips if you’re ever tackling a project like this. We opted for a softwood timber deck for reasons I’ll explain on a later video. If you haven’t watched part 1 yet, this deck measures around 7m wide by 3.4m deep, so about 24m2. A quick reminder for the trolls, I don’t make sponsored videos but I love winding you up.

Download the plans I made for this deck and nerd out on loads of extra detail over on the Member Zone:
members.gosforthhandyman.com/decking-timber

Part 1 (deck base): youtu.be/LVsi2DFpS8M

Subscribe to my gaming channel:
youtube.com/@AndyMac

Buy an awesome Gosforth Handyman tape measure or T-shirt:
gosforthhandyman.com/shop

Subscribe to the free Gosforth Handyman newsletter:
gosforthhandyman.com/newsletter

Check out Charlie DIYte’s excellent video about different deck oils:
youtu.be/ZOQ2L1TMayc

TOOLS & PRODUCTS I USE: gosforthhandyman.com/products-i-use
INSTA: instagram.com/gosforthhandyman
X / TWITTER: https://x.com/gosforthandy
CORRECTIONS: gosforthhandyman.com/corrections

Chapters:
00:00 - Introduction
01:15 - Fitting the deck joist tape
02:05 - How long does it take?
05:50 - Install timelapse
06:28 - British weather!
08:05 - Inset step detail
12:07 - Tomatoes
12:25 - Installing the last deck boards
15:31 - Building the step
20:40 - Trim and poor timber quality
24:24 - Finishing with decking oil
26:20 - Final reveal

All content on this channel is exclusively owned by MacLellan Creative Limited. Copyright (c) 2024. All rights reserved.

#decking #woodworking #deckdesign
How I built our floor level timber deckingWe built a lean-to roof for our self-build extensionHow do you fit laminate worktop EDGE TRIM?Is your UK house COLD and DAMP?Is DIY lawn care a complete waste of time?How to identify ANY DeWalt product from the model numberWhy didn’t we install an Air Source Heat Pump? (1920’s Renovation Part 32)Week 1 for our brickie... and I’m the labourer!What if you door is TOO THIN for a tubular latch??Greek houses better... because theyre worse??Unblocking gutters, pigeon problems and trimming a door! (Renovation Part 4)Which framing nail gun did I buy?
Gosforth Handyman |

How I built our floor level timber decking

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER