Uploaded September 2016 | Updated November 2026, 3 hours ago
Inspired by a comment on a video over on the GarageWoodworks channel, I decided to try out three different methods for cutting rabbets.
Method #1 uses a router table.
Method #2 is the "two cut" method, otherwise known as the table saw with a standard blade
Method #3 also uses the table saw, but with a dado stack installed
Spoiler alert: all three methods result in a rabbet. However the time it takes to execute the cuts is different, as is the quality of the results.
As with all things woodworking there are no hard and fast conclusions. I have my preferences, but those are based almost entirely on my shop setup and biases. There's no reason to think that any of these methods (or any of the dozens not discussed) is "the way" to do it.
Inspired by a comment on a video over on the GarageWoodworks channel, I decided to try out three different methods for cutting rabbets.
Method #1 uses a router table.
Method #2 is the "two cut" method, otherwise known as the table saw with a standard blade
Method #3 also uses the table saw, but with a dado stack installed
Spoiler alert: all three methods result in a rabbet. However the time it takes to execute the cuts is different, as is the quality of the results.
As with all things woodworking there are no hard and fast conclusions. I have my preferences, but those are based almost entirely on my shop setup and biases. There's no reason to think that any of these methods (or any of the dozens not discussed) is "the way" to do it.










