Uploaded August 2023 | Updated September 2026, 1 week ago

---

I have been testing out the effect of changing the feed rate on our plasma table to see what it does to the quality of the cut. All cuts were from the same mild steel plate at 130A and I changed the feed rates in 5% increments from 100% down to 70%.

If you like my videos, please consider supporting my channel on Patreon. You'll get access to gag reels, early access to videos, and I'll give you a shout out in my videos.

patreon.com/stuartdeharo

Follow me on Instagram at instagram.com/stuartdeharo