HOW DO BLANKING PUNCHES CUT? HOW TO POSITION BLANKING PUNCHES IN RELATION TO THEIR DIES MARC LECUYER @THATLAZYMACHINIST

THATLAZYMACHINIST | HOW DO BLANKING PUNCHES CUT? HOW TO POSITION BLANKING PUNCHES IN RELATION TO THEIR DIES MARC LECUYER @THATLAZYMACHINIST | Uploaded August 2014 | Updated October 2024, 1 hour ago.
This video answers Martin's (Quebec, Quebec) question about centering or positioning a punch on a die set. This gives me the opportunity to talk about shim stock and also to explain the difference between chip formation and punching (blanking). I produce these videos to answer viewer questions about machining. As for all thatlazymachinist videos, this video is aimed at the novice machinist who wishes to develop proper basic work skills. MARC LECUYER, thatlazymachinist.com

THREADING ON THE LATHE, CHOOSING PLUNGE ANGLES & MEASURING WITH THE THREE WIRE METHOD, MARC LECUYER

DIVIDING HEAD #2 how to perform direct indexing, simple indexing and angular indexing operations.

Q&A 2 Nesting jigs, plastics (polymers), EDM (electrical discharge machining) & my lathe tool post

GRINDING WHEEL PREPARATION INSTALLATION, STATIC BALANCING, SURFACING WITH DIAMOND DRESSER

HAMMER HANDLE #1 INTRODUCTION TO LATHE WORK (layout, surfacing, center drilling) THATLAZYMACHINIST

ELECTRICAL DISCHARGE MACHINING EDM, MARC LECUYER

CUTTING LIP ANGLES & TOOL HEIGHT FOR TURNING & FACING OPERATIONS WHEN MACHINING WITH AN ENGINE LATHE

ACCURATE POCKET MILLING BY COORDINATES USING A DIGITAL READOUT, ROUGHING & FINISHING, MARC LECUYER

THE 1-2-3 BLOCK PART 1 : PREPARING THE ROUGH PART, SQUARING UP, LAYOUT AND MILLING, MARC LECUYER