Uploaded July 2020 | Updated September 2026, 1 week ago
This is a response video to a viewer question from my very first video. User Ro K asked how accurate it was to use T-slot pins to locate parts on the milling machine table. The answer, in my case anyway, is not bad, but not spot on either. For most work, it will get you plenty close, but if you need it to be perfect, indicate it in. Your mileage may vary, especially if you have a machine that was not abused earlier in its life.
I have a new Patreon page! The YouTube content isn't going to change at all, but Patrons will be treated to occasional gag reels and outtakes, plus the opportunity for me butchering their name on camera. Check it out here:
patreon.com/stuartdeharo?fan_landing=true
This is a response video to a viewer question from my very first video. User Ro K asked how accurate it was to use T-slot pins to locate parts on the milling machine table. The answer, in my case anyway, is not bad, but not spot on either. For most work, it will get you plenty close, but if you need it to be perfect, indicate it in. Your mileage may vary, especially if you have a machine that was not abused earlier in its life.
I have a new Patreon page! The YouTube content isn't going to change at all, but Patrons will be treated to occasional gag reels and outtakes, plus the opportunity for me butchering their name on camera. Check it out here:
patreon.com/stuartdeharo?fan_landing=true
