Uploaded August 2021 | Updated November 2026, 2 days ago
Here's a schematic for this clump of circuitry with a few improvements: drive.google.com/file/d/1bYoKzUYzx5S2iu_MdMfdLdKqZu2TdcSu/view?usp=sharing
Audio comes in to the circuit through an attenuating potentiometer and then an amplifier that will clip/saturate the signal at 5 volts peak-to-peak.
The next stage centers the audio signal around 2.5V, to take full advantage of the next stage, which is a ADC0820, which turns the audio level into an eight-bit number. The ADC0820 has an "interrupt" function that lets you send it a clock and basically lower the sample rate of the audio.
The bits then go to a pair of CD4066 quad bilateral switch ICs, which get their gates turned on or off with a comparator ladder that turns off each bitstream, starting with the least significant bit, up to the next-to-most significant bit (the MSB can always get through).
Then the bits get processed by another comparator ladder, with resistors between the outputs and the less-significant-bits down the ladder, so the values of the more-significant-bits get duplicated down the line -- bitcrushers that leave their "crushed" bits at high-impedance state lose loudness as the bits get crushed, this one doesn't (it gets LOUDER). Finally, the byte gets turned back into audio with a DAC0808 chip...
...and that's what's going on inside this circuit.
Here's a schematic for this clump of circuitry with a few improvements: drive.google.com/file/d/1bYoKzUYzx5S2iu_MdMfdLdKqZu2TdcSu/view?usp=sharing
Audio comes in to the circuit through an attenuating potentiometer and then an amplifier that will clip/saturate the signal at 5 volts peak-to-peak.
The next stage centers the audio signal around 2.5V, to take full advantage of the next stage, which is a ADC0820, which turns the audio level into an eight-bit number. The ADC0820 has an "interrupt" function that lets you send it a clock and basically lower the sample rate of the audio.
The bits then go to a pair of CD4066 quad bilateral switch ICs, which get their gates turned on or off with a comparator ladder that turns off each bitstream, starting with the least significant bit, up to the next-to-most significant bit (the MSB can always get through).
Then the bits get processed by another comparator ladder, with resistors between the outputs and the less-significant-bits down the ladder, so the values of the more-significant-bits get duplicated down the line -- bitcrushers that leave their "crushed" bits at high-impedance state lose loudness as the bits get crushed, this one doesn't (it gets LOUDER). Finally, the byte gets turned back into audio with a DAC0808 chip...
...and that's what's going on inside this circuit.










