Grounding, Bonding, Earthing, Shielding and Protecting with Jim Heath W6LG @ham-radio

Grounding, Bonding, Earthing, Shielding and Protecting with Jim Heath W6LG @ham-radio

Uploaded March 2019 | Updated September 2026, 2 weeks ago

What are grounding, bonding, earthing, shielding and protecting in the amateur radio station? This is Part 1 of a series of videos. Should you run a ground wire to the transceiver; maybe not! Watch and find out why. Comments are encouraged.

Grounding, Bonding, Earthing, Shielding and Protecting with Jim Heath W6LG

What is that THUD??

FTDX3000 AL811H LDG1000 How Do You Tune This Equipment? Why Does The SWR Change? Jim W6LG Explains

NanoVNA 2 With Jim Heath W6LG Measured Very Little Loss With 60 Connectors At 140MHz

Vertical Dummy Load & Antenna Which Part Does the Most Radiation? Jim is Out of the Hospital

This is My Homebrew 3 Element Yagi at 30 Feet Maximum on a Remotely Controlled Tubular Tower at W6LG

Incredible Computer that Delivers a Beautiful Gray Line Map at an Amazing Price with Jim Heath W6LG

Building a Ham Radio Station with YouTube Elmer. Jim Heath W6LG Part 2

End Fed, Dipole, Off Center Fed Antennas: Which is better? Jim W6LG Shows a Brief Animation

How Much Does It Cost to Setup an HF Ham Radio Station by Jim Heath W6LG with Advice from Rod K5FRH

AA-35 Zoom From RigExpert Coax Cable Loss And Length Of Coax Cable With Jim Heath W6LG

How Are Conditions? When To Listen for DX Ham Radio Basics with Jim Heath W6LG

Grounding, Bonding, Earthing, Shielding and Protecting with Jim Heath W6LG