Don Brandt | Grizzly G4000 9x20 4 Bolt Compound Clamp Mod @DonBrandt | Uploaded September 2017 | Updated October 2024, 7 hours ago.
Here is the first needed modification to you 9x20 Metal Lathe. A 4 bolt clamp used to steady your cutting tool. You can watch the process on making the clamp.
Steve Bedair LINK: bedair.org/clamp/9x20clamp.html
This is one of the first improvements needed on the 9 x 20 lathe's. I have included photos from start to finish to build your own clamp. I have also included measurements but please note that these are the measurements that worked for my HF 9 x 20 lathe. All the 9 x 20's are basically the same but exact measurements may differ.
Here is the first needed modification to you 9x20 Metal Lathe. A 4 bolt clamp used to steady your cutting tool. You can watch the process on making the clamp.
Steve Bedair LINK: bedair.org/clamp/9x20clamp.html
This is one of the first improvements needed on the 9 x 20 lathe's. I have included photos from start to finish to build your own clamp. I have also included measurements but please note that these are the measurements that worked for my HF 9 x 20 lathe. All the 9 x 20's are basically the same but exact measurements may differ.