Uploaded January 2013 | Updated November 2026, 22 hours ago
This video is of a Globalstar GSP-1600 in satellite mode. I place a call to a long recording then put the phone into engineering / debug / field test mode and show handoffs between spot beams and satellites as they traverse the sky above my location.
The GSP-1600 has a three-fingered CDMA rake receiver, meaning that it can receive and utilize up to three signals simultaneously. Each row on this screen shows the status of a single rake finger. The fields, from left to right, are [finger status] [satellite ID] [spot beam ID] [signal-to-(noise+interference) ratio].
I am not sure what each of the status codes means, but I believe that 'A' stands for active. Each Globalstar satellite transmits 16 separate signals (spot beams), each aimed in a different direction toward the earth. The spot beam(s) visible in a given location from a given satellite vary as the satellite moves across the horizon, and calls hand off between spot beams in much the same manner as they hand off between satellites.
The spot beam pattern is rather interesting; details can be found on page 6 of this document: tinyurl.com/bbyx7yk
This video is of a Globalstar GSP-1600 in satellite mode. I place a call to a long recording then put the phone into engineering / debug / field test mode and show handoffs between spot beams and satellites as they traverse the sky above my location.
The GSP-1600 has a three-fingered CDMA rake receiver, meaning that it can receive and utilize up to three signals simultaneously. Each row on this screen shows the status of a single rake finger. The fields, from left to right, are [finger status] [satellite ID] [spot beam ID] [signal-to-(noise+interference) ratio].
I am not sure what each of the status codes means, but I believe that 'A' stands for active. Each Globalstar satellite transmits 16 separate signals (spot beams), each aimed in a different direction toward the earth. The spot beam(s) visible in a given location from a given satellite vary as the satellite moves across the horizon, and calls hand off between spot beams in much the same manner as they hand off between satellites.
The spot beam pattern is rather interesting; details can be found on page 6 of this document: tinyurl.com/bbyx7yk









![Blues Brothers via 4x ISDN BRI (512 kbit/s) [Polycom Viewstation]
The car may have a lotta pickup, but the video call doesnt have a lotta bits to work with!
This video shows a DVD being played back over the equivalent of 8 digital telephone lines (8x64 kbit/s) through my AT&T/Lucent/Avaya Definity PBX. This would have been a very fancy (and expensive) method of video telecommunication in the 1990s.
This video is being transmitted using two Polycom Viewstation 512 kbit/s TDM video conferencing sets. One of them connects to 4 ISDN BRI lines, and the other connects to 4 (proprietary) AT&T/Lucent/Avaya 2-wire DCP lines.
The four ISDN lines needed at each site would typically have cost around $240/mo per site, and the cost of a long distance video call at this quality would have been at least eight times the cost of a normal long distance voice call. (I say at least, because some telephone companies charged extra per-minute rates for 64 kbit/s-clean long distance calls, and you had to place 8 of them simultaneously to attain the 512 kbit/s data rate.) Blues Brothers via 4x ISDN BRI (512 kbit/s) [Polycom Viewstation]](https://i.ytimg.com/vi/I1f4f_O3y60/mqdefault.jpg)
