Getting To Blinky 4.0 - Building Blinky @contextualelectronics
Getting To Blinky 4.0 - Building Blinky @contextualelectronics
Uploaded June 2016 | Updated September 2026, 3 days ago
Soldering and troubleshooting the Getting To Blinky board. Will it blink??

Aoyue 937 Soldering Iron: amzn.to/1Z3y4YK
Solder tip cleaner: amzn.to/1SV7bEJ
Flux pen: amzn.to/1QNOHl9
Solder: amzn.to/1W3JRZy
Solder wick: amzn.to/24uhjti

This video is part of a series of videos getting a new user to building a board that blinks. It is an updated version of GTB, using the 4.0 version of KiCad.

View the entire series here: contextualelectronics.com/learning/getting-to-blinky-4-0
Download the latest KiCad version here: kicad-pcb.org/download
Getting To Blinky 4.0 - Building BlinkyThe State Of KiCad - V5.1 And Beyond! - Wayne Stambaugh (KiCon 2019)KiCad 5.0 - Adding dimension to your layoutCEP010 - Low Volume and Low Cost with TimonInstalling and using the Digikey KiCad LibraryHow to use Zephyr drivers to easily interface to sensors to microcontrollersKiCad 5.0 has arrived, new videos on the wayPreparing for Contextual ElectronicsKiCad 3.0 - Adding 3rd Party Footprints In KiCadKiCad 5.1 - Inserting DXF outlines into footprintsKiCad 5.0 - Custom Pad ShapesGetting Started With GitHub and KiCad (Hardware)
Contextual Electronics |

Getting To Blinky 4.0 - Building Blinky

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER