Getting started with the NeoDen4 (Part 1) - Introduction @contextualelectronics
Getting started with the NeoDen4 (Part 1) - Introduction  @contextualelectronics
Uploaded October 2018 | Updated November 2026, 2 days ago
I learned how to use the Pick and Place machine, the NeoDen4. There are some idiosyncrasies that I encountered and wanted to share with you.

Note for beginners: Most people do NOT need to use a Pick and Place machine. This is because I was planning on making a small-ish run of boards with a lot of components (288 LEDs on one side).

Support KiCad!

KiCad hat: contextualelectronics.com/product/kicad-hat
KiCad shirt: contextualelectronics.com/product/choose-your-side-shirt
Getting started with the NeoDen4 (Part 1) - IntroductionKiCad In Action: A Case Study for Stairwell Lighting - Steve Mayze (KiCon 2019)KiCad 5.0 - Adding a new symbol libraryImporting Eagle files into KiCad 5.1CEP013 - Open Source Robotics with Kat ScottKiCad 5.0 - Selecting traces for rip upKiCad 3.0 - Ad Hoc Via Stitching in KiCadCreating a fab drawing and stack up using a custom footprint in KiCadKiCad 5.0 - Improving trace visibility during layout3D modeling a wheel using SketchupFrom Idea To Production: Using KiCad For OSHW Design And Mfg - Piotr Esden-Tempski (KiCon 2019)KiCad 5.0 - Custom Solderpaste Stencil Elements
Contextual Electronics |

Getting started with the NeoDen4 (Part 1) - Introduction

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER