Fusion 360 - Hexagon Pattern on a Cylinder using Emboss @KristianLaholm
Fusion 360 - Hexagon Pattern on a Cylinder using Emboss  @KristianLaholm
Uploaded August 2020 | Updated November 2026, 5 days ago
This is my workflow of putting a hexagon pattern on a cylinder.
It only take 4 steps but the workflow can be improved :)
Fusion 360 - Hexagon Pattern on a Cylinder using EmbossHow to Deconstruct a Sketch in Autodesk Fusion and Find ConstraintsFusion 360 Basic - Handle (FB Question)Fusion 360 - Spiral Wind TurbineFusion 360 - Fillet Tetrahedron (2022 januari challenge workflow)Fusion 360 - Wave-Ribs on a Vase or Office Organizer.Fusion 360 (Basic) - From measurement to model, my workflow.Conical Cup Holder Replacement in Autodesk Fusion (1 Sketch, 1 Feature Workflow)Autodesk Fusion: Ellipsoid Modeling with the Scale ToolFusion 360 Challenge - Workflow Fixed PatternFusion Guide: Geometric Vase, the power of geometry.Fusion 360 (Basic) - One Model, Two different Workflows (Sketch vs. Features)
Kristian_Laholm |

Fusion 360 - Hexagon Pattern on a Cylinder using Emboss

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER