Fusion 360 - Edit a Mesh Bow Handle, not converting the mesh. @KristianLaholm
Fusion 360 - Edit a Mesh Bow Handle, not converting the mesh.  @KristianLaholm
Uploaded August 2022 | Updated November 2026, 2 days ago
Here is an answer to a Reddit question about how to move 2 holes 2mm on a bow handle.

0:00 Intro
0:25 Inspecting Mesh
2:36 Mesh Section sketches
3:58 Extracting information from sketches
7:30 Sketch new holes position
10:35 Fill the old holes
11:08 Extrude tool bodies
12:00 Tesselate and combine Mesh
12:33 Wait for Fusion
13:30 Check mesh
14:15 New holes Extrude tool bodies
15:48 Tesselate and combine Mesh
16:18 Fusion "Dark mode" do NOT panic for 2 minutes
18:20 Check final mesh
19:10 Save Mesh and Check in Slicer (Prusa)
Fusion 360 - Edit a Mesh Bow Handle, not converting the mesh.Mobius Strip in Fusion 360 - (Sweep and Circular pattern)Fusion 360 Basic - Exercise 1 (Sketch, Extrude and Move Rotate Face)Fusion 360 - Tennis BallFusion 360 - Trammel of Archimedes (Workflow with Joints)Fusion 360 - Parametric concentric spheres or The Useless Workflow ;)Fusion 360 - Sheet Metal overlapping cornerOctahedron - Easy in Fusion 360 - No Math or AnglesGeodome 4V Icosahedron in Fusion 360 - Geometric solution (no math)Fusion 360 - Helical Top (Surface tools)Fusion 360 Challenge - Parametric PatternFusion 360 Basic - Socket for Hex Knob - FB Question
Kristian_Laholm |

Fusion 360 - Edit a Mesh Bow Handle, not converting the mesh.

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER