Uploaded September 2022 | Updated November 2026, 1 hour ago
Creating an indent AFTER the heatsink fins have been created.
Starting file for thin fin example:
a360.co/3Rrnrk0
Starting file for thick fin example:
a360.co/3wKn63X
If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true
Disclosure: Autodesk has kindly sponsored the full version of Fusion 360 that is used to produce the videos on this channel. That being said, Autodesk has no editorial control over the content on this channel. I am still an independent creator with the aim of creating videos that help viewers in using Fusion 360. These videos are not meant to promote Fusion 360 as a product.
#fusion360school
Creating an indent AFTER the heatsink fins have been created.
Starting file for thin fin example:
a360.co/3Rrnrk0
Starting file for thick fin example:
a360.co/3wKn63X
If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true
Disclosure: Autodesk has kindly sponsored the full version of Fusion 360 that is used to produce the videos on this channel. That being said, Autodesk has no editorial control over the content on this channel. I am still an independent creator with the aim of creating videos that help viewers in using Fusion 360. These videos are not meant to promote Fusion 360 as a product.
#fusion360school










