Uploaded October 2026 | Updated November 2026, 2 days ago
FREE ! Essential RC Launch Dolly for Small EDF Jets
DOWNLOAD HERE: thingiverse.com/thing:7395721
This is the launch dolly that Nick and I have been using recently to consistently get our small EDF jets into the air. We have found this method of launching far less risky than hand launching and bungee assisted launching. Nick designed this to use with his 70mm EDF Shark jet but it also works for the 90mm EDF Psycho if the stock front posts are elongated in TinkerCAD or your preferred slicer by 50%.
The 3D printed parts are for the front and back parts. 4 x 30cm sections of 21.5mm plumbers pipe is needed to hold these parts together. Use 2 x 26cm sections of foam pipe insulation on the top 2 pipes to cushion your model.
You will also need 2 x 6cm (2.5 inch) foam front wheels with bolts and nuts to hold them to the bottom of the front frame part. A smaller 5cm foam back wheel is needed again with bolt and nut to act as the axle on the rear frame part.
We hope this simple but effective launch dolly helps you get your small RC EDF jets into the air successfully every time. Please share it with fellow RC pilots.
DOWNLOAD HERE: thingiverse.com/thing:7395721
#3Dprinting #rcplane #bambulab
Filmed by Dom and Nick using the Panasonic HC-X2 Pro 4K camcorder for the Essential RC YouTube channel at my local model flying club.
Don't forget to SUBSCRIBE for regular 'Essential RC' action using this link youtube.com/c/EssentialRC?sub_confirmation=1
SUPPORT 'Essential RC' and JOIN HERE youtube.com/c/EssentialRC/join for EARLY ACCESS to NEW videos
CHECKOUT OUR UNIQUE RC T-SHIRTS AND MERCH HERE:
essentialrc-shop.fourthwall.com
FREE ! Essential RC Launch Dolly for Small EDF Jets
DOWNLOAD HERE: thingiverse.com/thing:7395721
This is the launch dolly that Nick and I have been using recently to consistently get our small EDF jets into the air. We have found this method of launching far less risky than hand launching and bungee assisted launching. Nick designed this to use with his 70mm EDF Shark jet but it also works for the 90mm EDF Psycho if the stock front posts are elongated in TinkerCAD or your preferred slicer by 50%.
The 3D printed parts are for the front and back parts. 4 x 30cm sections of 21.5mm plumbers pipe is needed to hold these parts together. Use 2 x 26cm sections of foam pipe insulation on the top 2 pipes to cushion your model.
You will also need 2 x 6cm (2.5 inch) foam front wheels with bolts and nuts to hold them to the bottom of the front frame part. A smaller 5cm foam back wheel is needed again with bolt and nut to act as the axle on the rear frame part.
We hope this simple but effective launch dolly helps you get your small RC EDF jets into the air successfully every time. Please share it with fellow RC pilots.
DOWNLOAD HERE: thingiverse.com/thing:7395721
#3Dprinting #rcplane #bambulab
Filmed by Dom and Nick using the Panasonic HC-X2 Pro 4K camcorder for the Essential RC YouTube channel at my local model flying club.
Don't forget to SUBSCRIBE for regular 'Essential RC' action using this link youtube.com/c/EssentialRC?sub_confirmation=1
SUPPORT 'Essential RC' and JOIN HERE youtube.com/c/EssentialRC/join for EARLY ACCESS to NEW videos
CHECKOUT OUR UNIQUE RC T-SHIRTS AND MERCH HERE:
essentialrc-shop.fourthwall.com










