Uploaded May 2017 | Updated November 2026, 3 hours ago
Demo of pulling too hard during high speed with a rc FPV wing.
Pulling too far back and/or too fast during flight causes the wing to stall. The stall is when the "critical angle of attack" is exceeded. Angle of attack is the angle measured between the chord of the wing (line drawn from leading edge to trailing edge) and the wind. At that point there is no longer airflow over the wings to support lift. This can occur at any speed.
Once the wing is stalled, torque of the motor takes over, since the elevens can not help with roll any longer. This torque flips the wing in the opposite direction of prop rotation ( Newtons 3rd law. For every action there is an equal and opposite reaction.)
This flip occurs when the motor is producing power. If the motor is at idle and the wing (both left and right) are stalled, it would just stall without any rolling.
Torque rolls are most common during takeoff. Takeoffs involve high power settings and little airspeed. The key to a successful launch is one consistent power setting and not moving the control elevens too soon after launch. Wings like speed.
Other factors that help contribute to a torque roll.
1. Small wingspan vs props size
2. Over propped wing (too long and pitch is too high)
3. Size and throw of elevons.
4. Power of the motor.
5. CG is too far fwd (Run out of elevator authority too soon)
6. CG is too far aft.
Demo of pulling too hard during high speed with a rc FPV wing.
Pulling too far back and/or too fast during flight causes the wing to stall. The stall is when the "critical angle of attack" is exceeded. Angle of attack is the angle measured between the chord of the wing (line drawn from leading edge to trailing edge) and the wind. At that point there is no longer airflow over the wings to support lift. This can occur at any speed.
Once the wing is stalled, torque of the motor takes over, since the elevens can not help with roll any longer. This torque flips the wing in the opposite direction of prop rotation ( Newtons 3rd law. For every action there is an equal and opposite reaction.)
This flip occurs when the motor is producing power. If the motor is at idle and the wing (both left and right) are stalled, it would just stall without any rolling.
Torque rolls are most common during takeoff. Takeoffs involve high power settings and little airspeed. The key to a successful launch is one consistent power setting and not moving the control elevens too soon after launch. Wings like speed.
Other factors that help contribute to a torque roll.
1. Small wingspan vs props size
2. Over propped wing (too long and pitch is too high)
3. Size and throw of elevons.
4. Power of the motor.
5. CG is too far fwd (Run out of elevator authority too soon)
6. CG is too far aft.










