Foundry Pattern Making for Brass Casting @DonBrandt
Foundry Pattern Making for Brass Casting  @DonBrandt
Uploaded September 2016 | Updated November 2026, 16 hours ago
Designing, machining, and finishing pattern for my flywheel castings. Draft angles allow for easy release from the mold. Can cast aluminum, brass, copper, etc. This is a re-edited version of previously posted videos to my channel. I learned all the casting methods from myfordboy. Check out his channel!
youtube.com/user/myfordboy

The long version version of these videos are:

Brass casting: #8 Creating a new flywheel pattern with draft angle
youtu.be/CmHRWEdbRVU?list=PLtK1aWpQEwRIgMEUm2iZI_0WPGDFzqfAB

Brass casting: #9 Pattern making Flywheel Hub with draft angle
youtu.be/L5PDvF9qNXQ?list=PLtK1aWpQEwRIgMEUm2iZI_0WPGDFzqfAB

Brass casting: #10 flywheel spoke pattern making
youtu.be/jpDI4QporSE?list=PLtK1aWpQEwRIgMEUm2iZI_0WPGDFzqfAB

Brass casting: #11 completing the flywheel pattern
youtu.be/Rr11ICUkDZ4?list=PLtK1aWpQEwRIgMEUm2iZI_0WPGDFzqfAB

Heading West by Audionautix is licensed under a Creative Commons Attribution license (creativecommons.org/licenses/by/4.0/)
Artist: audionautix.com
Foundry Pattern Making for Brass CastingHARBOR FREIGHT 6.5 OHV Horizontal Shaft Gas Engine review and Go-cart Project Part #2Viewer Recommended Casting Flask ImprovmentsYamaha FZ-09 Bar end Mirror install and modification (Knock off - CRG Arrow bar end Mirror)Building a Telecine Machine - Part 1, 15 FPS Test FootageBehind the Scenes, Camera filming and hardware tips Part 1, 18650 battery packCool LED Filament Bulb reviewCarbide Insert parting Tool review (MGEHR1212-2)Building a Telecine Machine - Part 5, Back-light ElectronicsBattery park: motor sizesUPAIR ONE DRONE  at the Alton IL riverfrontBuilding a precision oscillating steam engine: Part 4
Don Brandt |

Foundry Pattern Making for Brass Casting

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER