Uploaded May 2026 | Updated September 2026, 2 weeks ago

---

I'm getting ready to install the AirWeights vacuum hold down system on my Onefinity Foreman CNC. I set up the flattening tool path in Vectric Aspire and then created the gcode and imported into the Redline CNC controller. I set the depth for 0.03". After the first pass I had a low spot in the center of my spoil board so I lowered the Z origin by 0.02" and ran the pass again.

vectric.com

@vectric @OnefinityCNC @RedlineCNCOfficial #vectric #onefinitycnc #redlinecnc #CNC #flattening