First PMG build from scratch! @UMGMentor
First PMG build from scratch!  @UMGMentor
Uploaded November 2015 | Updated November 2026, 3 hours ago
This is the build of my first permanent magnet generator or PMG. This took me months of thinking and planning to go from knowing nothing but interest to doing it. And since I don't get out much, I watched a few videos on you tube as my instructors if you will.
While getting testy my wife gave me this project, So I may have build it but I dedicate the project to her.
So darling for the hours of listening to me babl on about stuff you never heard of.
And tolerating abstract writings on your bathroom mirrors. I dedicate this to you.
My compass!

Cost for build about 350 dollars to date.

Type build is 3 phase delta circuit with 8 coils per leg.
18 gauge wire 140 wraps each
resistance 3.1 ohms per leg
Magnets are Neodymium REM N 52
72 Magnets on wheel.
22 in diameter inner wheel.
26 in diameter outer wheel

Produced 60 vdc at 120 rpm peddle wheel
1 to 7 ration on inner wheel so 840 rpm
First PMG build from scratch!L & D Trucking - DOT Physical & killing a Havalina
Wayne |

First PMG build from scratch!

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER