First large print on the bambu x1c @rgs1
First large print on the bambu x1c @rgs1
Uploaded April 2023 | Updated September 2026, 1 hour ago
I've run a few small test prints on the bambu x1 carbon all worked well

so thought I'd try a large print, the almost required 'poop bucket'

I am pleased at the quality of this printer, first layers like I have never seen before, and speed.. this thing is fast, this print took about 4 hours, on my ender3 it would have been about 12 hours and the quality would not have been as good

the only real downside to this printer is its load.. where my ender is almost silent
First large print on the bambu x1cMedtronic 780g glow in the dark pump skinStainless steel tankard engrave on a JPT MOPA fiber laserJerry the JirdMy first 3d print with Octoprint and OctolapseSamsung Galaxy S3 wireless charging from the Palm TouchstonePitaka glow in the dark phone case, the Pitaka Alien #pitakaFirst attempt with zinc alloy challenge coin from alibaba on the em-smart one 20w raycus fiber laserStainless steel tankard on a rotary with 80w jpt mopa - spell check first though :-(Lightburn repeat marking on pensHumaPen SavvioMy Custom Ruger 10 22 with prices
Richard Searley |

First large print on the bambu x1c

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER