Uploaded August 2024 | Updated September 2026, 2 weeks ago

---

Sorry for the poor quality. I was mainly trying to get this method documented not make a tutorial. I will try to shoot an actual tutorial video later.

Material List
- 16” of ⅞” OD, 0.058” Wall, Aluminum Tube
- 3” of 1.0” OD, 0.058” Wall, Aluminum Tube
- 3” of ¾” OD Steel Slug - 304 / 304L and Epoxy to hold slug
- 7 ft of ⅛” Technora Rope, 18” doubled over or ⅛” Twisted Kevlar Cord
- 3” x 24” x ⅙” thick Nomex Felt
- 80 ft of 1/16” Thick, ½” Wide, Kevlar Wick for a 6 Plait Belly and 8 Plait Overlay
- Kevlar Thread and Needle
- PVA glue for Thong Lash
- ⅞” diameter Chair tip
- Tennis Racket Grip
- Heat Resistant Silicone Tape
- Technora Line for Poppers

The cost is approximately $100 in total
$50 Kevlar
$10 Aluminum
$10 Technora
$10 Felt
$5 Silicone
$5 Grip
$10 Misc Hardware

2023 Method / Steps
1) Cut Handle
2) Cut Collar
3) Cut Slug
4) Epoxy / Rivet Slug
5) Double & Loop Technora, 7 ft
6) Nomex Bolster, 24 inches
7) 6 plait belly, 4 feet
8) 8 plait overlay, 5.5 feet
9) Sew & Glue thong
10) Heel Cap, Grip, & Silicone
11) Attach Handle, Collar & Thong
12) Technora Popper

Notes for future April
- Plan out the whip
- Have Measurements Done
- Wide Screen Aspect Ratio
- Check Framing
- Use a Microphone
- Close-up of all detail shots
- Use a Ring Light
- Copyright Free Background Music