Finishing  - Applying Shellac to my Joiners Mallet - Part 1 @McGinnsWoodShop
Finishing  - Applying Shellac to my Joiners Mallet - Part 1  @McGinnsWoodShop
Uploaded April 2014 | Updated September 2026, 2 weeks ago
Here I apply my first two coats of Shellac. I don't mention when I started my second coat, but it's basically when it starts to get tacky.

I don't even know if that constitutes 2 coats to be honest, but it's a tactic non the less.

Please share your knowledge on Shellac while Part 2 is produced and published
Finishing  - Applying Shellac to my Joiners Mallet - Part 1Lieutenant General 160-1 Lathe Cleanup & Turning an Elm Bowl!McGinns WoodShop   Making a Fall Pumpkin DecorationThe Wooden BBQ  for Javis Useless ChallengeTurned WINE GLASS from LILACFixing the Pull Start on my Snow BlowerWhats up yo!Introduction McGinns Woodshop 2015Milling a large Elm Log into 12 by 11 by 53 inch block BOOM!Maritime Woodworkers Spotlight TrailerMcGinns Woodshop TourLive - Getting 10 Cord of Wood 8Footers
McGinns WoodShop |

Finishing - Applying Shellac to my Joiner's Mallet - Part 1

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER