Uploaded June 2023 | Updated November 2026, 3 hours ago
In 2022 I improved on my Famicom AV mod to try to reduce jailbars as much as possible. In this video I am using the same system but using a different amplifier board. I removed the CatHouse video amplifier and installed the Famicom Composite Adapter from Retro Game Restore. That board is more convenient to install as it is small enough to rest in between the pins of the PPU on the solder side of the Famicom's mainboard. It also has a pair of surface mount tantalum capacitors to filter out noise in the PPU's power signal.
I had pulled the video output pin of the PPU, Pin 21 out of its socket to reduce the jailbars. I tried putting the pin back into the socket but broke it off. As there was only a sliver of metal sticking out of the PPU's plastic encapsulation I had to grind the plastic down with a dremel until I could expose enough of the track to solder a wire. I snaked a wire around the PCB to the underside to avoid the jailbar route as I had done with the Cathouse Games board. The video out and ground wires from the Adapter were connected directly to the 3.5" socket of the Power VAMP v3 board.
The end result as shown here may show jailbars noticeably where my previous video did not but I would note that YouTube has been increasingly unkind to older "SD-only" videos, compressing them to the point where they look worse now than they did when originally updated.
In 2022 I improved on my Famicom AV mod to try to reduce jailbars as much as possible. In this video I am using the same system but using a different amplifier board. I removed the CatHouse video amplifier and installed the Famicom Composite Adapter from Retro Game Restore. That board is more convenient to install as it is small enough to rest in between the pins of the PPU on the solder side of the Famicom's mainboard. It also has a pair of surface mount tantalum capacitors to filter out noise in the PPU's power signal.
I had pulled the video output pin of the PPU, Pin 21 out of its socket to reduce the jailbars. I tried putting the pin back into the socket but broke it off. As there was only a sliver of metal sticking out of the PPU's plastic encapsulation I had to grind the plastic down with a dremel until I could expose enough of the track to solder a wire. I snaked a wire around the PCB to the underside to avoid the jailbar route as I had done with the Cathouse Games board. The video out and ground wires from the Adapter were connected directly to the 3.5" socket of the Power VAMP v3 board.
The end result as shown here may show jailbars noticeably where my previous video did not but I would note that YouTube has been increasingly unkind to older "SD-only" videos, compressing them to the point where they look worse now than they did when originally updated.










