Uploaded April 2014 | Updated September 2026, 2 days ago
This is the first outing of my completed DLSR camera stabiliser based on the open-hardware EvvGC controller board. The gimbal frame and motors are from China. I've been at this for a few months now, and could never get it to stabalise, but this weekend I stripped down and re-built it, focussed on where the vibration was and eventually managed to get rid of it. Placement of the sensor board is crucial, as it wasn't firmly screwed on to the gimbal, and was one of the main sources of vibration. Tuning takes hours, but with patience, will settle eventually, once everything else is set up ok.
This is the first outing of my completed DLSR camera stabiliser based on the open-hardware EvvGC controller board. The gimbal frame and motors are from China. I've been at this for a few months now, and could never get it to stabalise, but this weekend I stripped down and re-built it, focussed on where the vibration was and eventually managed to get rid of it. Placement of the sensor board is crucial, as it wasn't firmly screwed on to the gimbal, and was one of the main sources of vibration. Tuning takes hours, but with patience, will settle eventually, once everything else is set up ok.
