Uploaded February 2023 | Updated November 2026, 3 hours ago
Here's a pick and gut of an Evva3ks in about a minute.
(tray by vitsona; tool by m.c., shaping inspired by mr.blackmagic to thin out shaft; made from a sparrows blank)
00:00 - start
00:06 - key check
00:16 - setting all slides down to zero start
00:25 - pick enters lock (custom pick)
01:34 - O P E N
02:17 - c clip removal
02:46 -- core pulled out
03:01 - remove top bar (key control)
03:30 - remove first side bar show it put in tray
03:50 - remove/show second side bar
04:03 - that shows top of all sliders
04:17 - start taking out the sliders - poking from one side grabbing at the other
06:45 - showing the inside of bible
07:14 - showing the false gates of each slider
08:06 - showing core from side to front
08:23 - showing all lock bits on tray
08:34 - the end
Here's a pick and gut of an Evva3ks in about a minute.
(tray by vitsona; tool by m.c., shaping inspired by mr.blackmagic to thin out shaft; made from a sparrows blank)
00:00 - start
00:06 - key check
00:16 - setting all slides down to zero start
00:25 - pick enters lock (custom pick)
01:34 - O P E N
02:17 - c clip removal
02:46 -- core pulled out
03:01 - remove top bar (key control)
03:30 - remove first side bar show it put in tray
03:50 - remove/show second side bar
04:03 - that shows top of all sliders
04:17 - start taking out the sliders - poking from one side grabbing at the other
06:45 - showing the inside of bible
07:14 - showing the false gates of each slider
08:06 - showing core from side to front
08:23 - showing all lock bits on tray
08:34 - the end




